Your shopping cart is empty!
Micro Swiss E3D V6 Throat Plated Steel Wear Resistant Thermal Tube
Bisa dipakai untuk E3D v6 1.75mm Direct dan Bowden Hotend
Untuk print bahan Nylon, Carbon Fiber, Bahan lain dengan lebih bagus
This tube is an improvement over the stock E3D HeatBreak. It's made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.
Thread size on heater block side : M6x1
Therad size on heatsink side: M7x1
Filament Size : 1.75 mm
3D Zaiku merupakan Official Reseller dari Micro Swiss
Harga lebih murah dari beli di toko Micro Swiss langsung
Barang Ready Stok
